Rotary Surface Grinding

Blanchard Grinding, technically referred to as Rotary Surface Grinding, quickly removes stock from one side of a part: typically a part too large to be Double-Disc Ground. Parts as large as 48" x 84" or 60" x 72" can be ground. Dimensional tolerances to .001", parallelism to .001", and flatness to .001" are achievable. Using significantly greater horsepower than other grinding methods, Blanchard Grinding removes large amounts of stock quickly and efficiently.

Ideal for large parts such as rotary tables, mold plates, and vacuum chambers, Blanchard Grinding adds size versatility, eliminates mis-matches, and speeds turnaround time on large parts when compared to flycutting. This method provides a considerable time savings over surface grinding as well. Using proprietary TCI vacuum chucks, even thin, hard to hold configurations can be Blanchard Ground.

Premachining costs and turnaround time can be reduced by simultaneously Blanchard Grinding multiple parts. Multiple part grinding, along with cutting a large, Blanchard Ground blank into smaller parts, provides uniform part-to-part thickness tolerances and surface finishes at a lower unit cost.

Materials which can be Blanchard Ground include Aluminum, Stainless, Brass, Copper, Titanium, Other Ferrous and Non-Ferrous Metals, Fineneblankings, Stampings, Mold Sets, Fabricated Assemblies, and Tapered Configurations KEYWORDS for this process: reciprocating, grinders


Home |  About Us |  Back To Technical Library |  Contact Us
Copyright © 1996-2017 JobShop.com. All Rights Reserved.
General or Technical Questions? E-mail support@JobShop.com