This technical information has been contributed by
Deep Springs Technology

Click here to find suppliers

A Metal Composite That Will (Literally) Float Your Boat


A new metal matrix composite could improve automotive fuel economy because it is light-weight and heat resistant.
Photo courtesy of New York University Polytechnic School of Engineering.

BROOKLYN, N.Y.—Researchers have demonstrated a new metal matrix composite that is so light that it can float on water.

Although syntactic foams have been around for many years, this is reported to be the first development of a lightweight metal matrix syntactic foam. It is the work of a team of researchers from Deep Springs Technology (DST) and the New York University Polytechnic School of Engineering.

The new material promises to improve automotive fuel economy because it combines light weight with heat resistance, according to researchers.

The newly developed magnesium alloy matrix composite is reinforced with silicon carbide hollow particles and has a density of only 0.92 grams per cubic centimeter compared to 1.0 g/cc of water. Not only does it have a density lower than that of water, it is strong enough to withstand the rigorous conditions faced in the marine environment, according to researchers.

Significant efforts in recent years have focused on developing lightweight polymer matrix composites to replace heavier metal-based components in automobiles and marine vessels. The technology for the new composite is very close to maturation and could be put into prototypes for testing within three years. Amphibious vehicles, such as the Ultra Heavy-Lift Amphibious Connector (UHAC) that is currently being developed by the U.S. Marine Corps., can especially benefit from the light weight and high buoyancy offered by the new syntactic foams, researchers explained.

“This new development of very light metal matrix composites can swing the pendulum back in favor of metallic materials,” said Nikhil Gupta, an NYU School of Engineering professor in the Department of Mechanical and Aerospace Engineering and the study’s co-author, in a press release. “The ability of metals to withstand higher temperatures can be a huge advantage for these composites in engine and exhaust components, quite apart from structural parts.”

The syntactic foam made by DST and NYU captures the lightness of foams, but adds substantial strength. The secret of this syntactic foam starts with a matrix made of a magnesium alloy, which is then turned into foam by adding strong, lightweight silicon carbide hollow spheres developed and manufactured by DST. A single sphere’s shell can withstand pressure of over 25,000 pounds per square inch (psi) before it ruptures—one hundred times the maximum pressure in a fire hose.

The hollow particles also offer impact protection to the syntactic foam because each shell acts like an energy absorber during its fracture. The composite can be customized for density and other properties by adding more or fewer shells into the metal matrix to fit the requirements of the application. This concept can also be used with other magnesium alloys that are non-flammable.

The new composite is said to have potential applications in boat flooring, automobile parts, and buoyancy modules, as well as vehicle armor.

The authors recently published their findings in the International Journal of Impact Engineering. “Dynamic Properties of Silicon Carbide Hollow Particle Filled Magnesium Alloy (AZ91D) Matrix Syntactic Foams” is available online at www.sciencedirect.com. This research is conducted in collaboration with the U.S. Army Research Laboratory.

This technical information has been contributed by
Deep Springs Technology

Click here to find suppliers

Home |  About Us |  Back To Technical Library |  Contact Us
Copyright © 1996-2017 JobShop.com. All Rights Reserved.
General or Technical Questions? E-mail support@JobShop.com