This technical information has been contributed by
Pacific Wire Products

Wire Forms and Custom Welded Wire Assemblies

Article1.jpgThe manufacture of steel wire forms and welded wire assemblies demands a tremendous amount of knowledge and experience. The final product can only be optimally achieved after matching the materials, processes, equipment design and quantities with the application. The designer should be aware that a practical and reasonable approach to tolerance is important to the overall cost of a part. Generally tighter tolerances will increase the product cost.

Wire shape, size and selection of the alloy (low carbon steel, stainless steel, aluminum or hard drawn) is where it all begins. Wire is typically purchased in coil form and is straightened and cut automatically on high-speed machines to tolerances within ± .010".

Article3.jpgMany wire fabricators recommend that the minimum bend or radius should be equal to the wire diameter. There are exceptions due to product function. In some instances the inside radius must be smaller than the wire diameter. When requiring a smaller radius, a crimping operation could be done, but with special tooling.

Wire is bent or formed with a variety of equipment. Rotary air benders, press brakes, punch presses, CNC wire benders and four-slide formers are used. Steel and stainless steel wire formed products, wire parts and problematic wire forms are all formed on this type of equipment. Depending on the equipment, standard or special tooling is required. Typical tolerances for wire forming fall into a range from ± .015" to ± .030".

Another major consideration in wire forming is the design of mechanical joints in wire forms to fasten and assemble formed wire products together. Other considerations include threading (by die cutting or rolling); swaged, pierced and upset ends; fasteners and fastening systems; and sheet metal brackets. Resistance welding of wire products (cross wire, butt, tee, projection and line) along with gas arc welding should be considered. Article4.jpg

Multiple-wire products such as cross-wire panels and other skeletonized shapes are usually readied for welding by being assembled in special jigs and fixtures made from plastic, wood and metal. These fixtures hold the formed wire parts in place during welding. Some specialized machines weld multiple-wire products without utilizing a jig or fixture. The fixture is actually built into the machine and is part of the "set-up" of the machine. Typical tolerances fall into a range from ± .010" to ± .060". Wire is resistance welded using a variety of equipment configurations. Single-head welders, projection welders and higher-volume multiple-head welders are used to provide complete flexibility during processing.

The finishing of wire products is also an important consideration. Basically, the wire product is completely manufactured before applying a finish. The finishing choices are nickel/chrome, zinc, powder coating, nylon or vinyl coating, black oxide, electropolish or passivation.

A full-service wire forming and welded wire assembly company provides product design assistance, prototypes, in-house tooling fixturing, short runs and production. The company should be capable of recommending simplified designs and practical solutions to your processing problems.

This technical information has been contributed by
Pacific Wire Products

Home |  About Us |  Back To Technical Library |  Contact Us
Copyright © 1996-2010 All Rights Reserved.
General or Technical Questions? E-mail